Spree Controls with Ruckus ECU
Posted: Tue Oct 08, 2019 1:24 pm
Hi all.
I'm doing a Ruckus GET engine swap on my 86' Spree and had a question about the starter switch wiring. I am using the original spree switch housing but running into an issue of the ignition coil not firing. The tail light will dim but there is no current coming from the ignition coil wires that connect to the coil itself. There is resistance on the ignition coil, so I am assuming everything is fine there.
The issue I may be running into is the correct way to wire the three wires from the spree switch housing and the 4 original wires that the Ruckus started switch had.
I'm stumped as I don't know what to do from here.
I'm doing a Ruckus GET engine swap on my 86' Spree and had a question about the starter switch wiring. I am using the original spree switch housing but running into an issue of the ignition coil not firing. The tail light will dim but there is no current coming from the ignition coil wires that connect to the coil itself. There is resistance on the ignition coil, so I am assuming everything is fine there.
The issue I may be running into is the correct way to wire the three wires from the spree switch housing and the 4 original wires that the Ruckus started switch had.
I'm stumped as I don't know what to do from here.