Page 1 of 1

won't idle properly

Posted: Sun Apr 24, 2005 3:17 pm
by HarleyRon
Finally got the 85 spree running after years of sitting up. Got a carb from ebay, cleaned it multiple times and added in-line fuel filter. Spree is a little difficult to start (sometimes have to hold throttle about 1/3 open) but once started runs down the street pretty good. Idle is crazy, it will idle way high for 10 or 15 seconds then drops down for a few seconds then back high then too low and dies. Any ideas?

Posted: Sun Apr 24, 2005 6:20 pm
by jimpomm
Check for air leaks around air filter and intake area.

Posted: Sun Apr 24, 2005 7:33 pm
by hondaman
Your float might be shot or not operating smoothly.
It might also be your choke is taking a dive or not seated all the way in.

Posted: Sun Apr 24, 2005 7:58 pm
by HarleyRon
Ok, I've checked for intake leaks and all seems well. Float and needle are new and have double checked them. I guess maybe the choke could be acting up.

Posted: Sun Apr 24, 2005 10:38 pm
by mikehailwood
How did you check for air leaks between the carb and the intake pipe? With the engine idling, I liberally spray starting fluid on the insulator block. If the idle speed temporarily increases, check for a crack or inefffective O-rings.