quick question
Moderator: Moderator
quick question
How do you get the magnetic thing on the side off ?
- burnt_toast
- Veteran OG
- Posts: 3592
- Joined: Sat Jul 31, 2004 8:00 pm
- Location: Atlanta, GA
the magnetic thing on the right side of the motor. if figure if i take it off i can get the rod off and pison and then slidfe the rod and piston overthe jug using a ring compressor and then connect the rod back to the motor. thats the only way i figure i can get this thing to run, because i just cant slide the jug over the piston without breaking a ring. do yall think that will work or shouild i just take it to the dealer?
i always put the jug just over the piston. u can take the pin out of the piston and slide it in the jug just enough to cover the rings. then u can use the ports to slide the pin back in.
00' sa-50 slammed and stretched
89' elite sb, with a 99' af16, (SOLD)
87' spree (SOLD
87' mustang gt vert kenne bell, irs.
90' mustang notch turbo drag car
12' wrx
89' elite sb, with a 99' af16, (SOLD)
87' spree (SOLD
87' mustang gt vert kenne bell, irs.
90' mustang notch turbo drag car
12' wrx