Problem with my 87'

HondaSE50 · Post by **HondaSE50** » Tue Aug 19, 2008 9:50 pm

I got a problem with my scooter , went i lift my rear wheel and i give gaz a dont have problem , but want i put on the floor and i try to run , the motor stop after 20 or 30 feets ...

What is the problem ?

Kenny_McCormic · Post by **Kenny_McCormic** » Tue Aug 19, 2008 10:38 pm

1. use english
2. i dont know

chevyguyjay · Post by **chevyguyjay** » Tue Aug 19, 2008 10:54 pm

throw a compression tester on there and c what u have. also, pull the carb apart. air filter could be dirty to.

HondaSE50 · Post by **HondaSE50** » Wed Aug 20, 2008 2:32 pm

chevyguyjay wrote:throw a compression tester on there and c what u have. also, pull the carb apart. air filter could be dirty to.

I make a compression test and everything look ok , a clean the carburator and i shoot a lot of carburator cleaner after the be sure ... and the air filter is clean ... i think is a problem with the gaz valve.

Kenny_McCormic wrote:1. use english
2. i dont know

Very helpful comments ...

Clivester · Post by **Clivester** » Wed Aug 20, 2008 3:03 pm

HondaSE50 wrote:I got a problem with my scooter , went i lift my rear wheel and i give gaz a dont have problem , but want i put on the floor and i try to run , the motor stop after 20 or 30 feets ...

Parlez-vous Francais?

HondaSE50 · Post by **HondaSE50** » Wed Aug 20, 2008 3:52 pm

Clivester wrote:
HondaSE50 wrote:I got a problem with my scooter , went i lift my rear wheel and i give gaz a dont have problem , but want i put on the floor and i try to run , the motor stop after 20 or 30 feets ...
Parlez-vous Francais?

Oui , je parle fran├â┬ºais et je suis du Qu├â┬®bec plus pr├â┬®cisement Montr├â┬®al !

dukemartini · Post by **dukemartini** » Wed Aug 20, 2008 4:31 pm

Kenny_McCormic wrote:1. use english
2. i dont know

* dude, English is this guys second language and he still is easier to understand then some of the Hawaiian guys on the site, cut him some slack.

stealth SE · Post by **stealth SE** » Wed Aug 20, 2008 5:51 pm

try setting your air screw on your carb at 1.25 turns out. engines run different under load.

Kenny_McCormic · Post by **Kenny_McCormic** » Wed Aug 20, 2008 8:48 pm

Sorry sounded like ghetto to me and not a french guy trying to use English.

HondaSE50:I would recommend you get a copy of the Mozilla Firefox web browser, it has a built in spell checker so you wont spell gas "gaz".

I would try cleaning the carb.

evilone · Post by **evilone** » Thu Aug 21, 2008 4:10 pm

Check spark plug. My elite was running real lean and acted just like what you're describing. The electrode was melted and insulator blistered. Ran great on stand, and died out before the end of the block.

HondaSE50 · Post by **HondaSE50** » Sat Aug 23, 2008 11:54 am

I just found my problem , this hole was completed jammed , no air passed , i clean everything and all work good now !

Kenny_McCormic · Post by **Kenny_McCormic** » Sat Aug 23, 2008 12:22 pm

Did you remove the small brass cartridge under the main jet and clean it out?http://www.hondaspree.net/phpBB2/viewtopic.php?t=5389 just blowing it out works but you will never get all the gunk out without removing it.

Honda Spree and Elite 50 Forums

Problem with my 87'

Problem with my 87'

Re: Problem with my 87'

Re: Problem with my 87'