No idle and gas in vaccum tube .

Trying to get your Spree/Elite to run, or run better? Post your questions here.

Moderator: Moderator

Post Reply
User avatar
smitty
Noob
Noob
Posts: 9
Joined: Mon Jul 23, 1973 10:24 am
Location: coatesville, In 46121

No idle and gas in vaccum tube .

Post by smitty »

Hey guys and or gals I'm still working on 86 spree that starts good but wont' idle ..plus gas is coming into the vac tube between carb and fuel valve...I took someones advice and removed the choke and put my finger over the opening and the motor would idle down but still had gas in vac. tube...so I'm guessing that my bystarter is no good but what is causing the gas to be in vac tube. :roll:
User avatar
ferchja
Spree
Spree
Posts: 187
Joined: Mon Jul 23, 1973 10:24 am
Location: Racine, WI

Post by ferchja »

Broken diaphram on the fuel valve. Get a used one and or new. The fuel is getting past the diapram and getting sucked into the intake down the vacuum.

Bystarter has nothing to do with the vacuum line to open the fuel valve.
Jeremy Ferch
1985 Spree (NQ50) - Mid restoration
User avatar
burnt_toast
Veteran OG
Veteran OG
Posts: 3592
Joined: Sat Jul 31, 2004 8:00 pm
Location: Atlanta, GA

Post by burnt_toast »

ferchja wrote:Broken diaphram on the fuel valve. Get a used one and or new. The fuel is getting past the diapram and getting sucked into the intake down the vacuum.

Bystarter has nothing to do with the vacuum line to open the fuel valve.
werd. sounds like a proken diaphram to me. New one at Honda dealer is about $35
projects galore :nerd:
User avatar
smitty
Noob
Noob
Posts: 9
Joined: Mon Jul 23, 1973 10:24 am
Location: coatesville, In 46121

gas in vac tube

Post by smitty »

Thanks --and i just bought this used one from Paul Richardson in Mich. who is trying to sell his business and he said it was fine!!!Waited a month to get it at that... :evil:
User avatar
noiseguy
Site Admin
Site Admin
Posts: 4421
Joined: Sat Jul 31, 2004 8:00 pm
Location: South Florida
Contact:

Post by noiseguy »

Check the valve operation per the manual to determine if it's really bad. If it is, write Paul back and tell him what's going on. Paul has been an honest dealer in the past, and I'm sure he'll make it right.
Admin, Hondaspree.net

Buy air filters and gaskets here (Ebay): http://stores.ebay.com/noiseguysstore
Buy air filters and gaskets here (Amazon): www.amazon.com/shops/spreepower
Buy a t-shirt here: https://teespring.com/stores/spree-powersport-products
User avatar
smitty
Noob
Noob
Posts: 9
Joined: Mon Jul 23, 1973 10:24 am
Location: coatesville, In 46121

re diapharm

Post by smitty »

just bought a new petcock and installed it and still get gas back in vac tube. plus the rascal still won't idle...ready to get new carg. Smitty;
User avatar
ferchja
Spree
Spree
Posts: 187
Joined: Mon Jul 23, 1973 10:24 am
Location: Racine, WI

Post by ferchja »

Do you have the tubes hooked up right? Or are you sure you know what the vacuum tube is? There is no way gas can get into the vacuum tube if the fuel valve is working properly.
Jeremy Ferch
1985 Spree (NQ50) - Mid restoration
Post Reply