R.P.M

fastgtp99 · Post by **fastgtp99** » Tue May 05, 2009 12:23 pm

Just out of curiousity I was wondering what kind of ideal rpm i should be running with my 94 elite. I have a 72cc bore, 28mm oko, dual reed manifold, 8 to 1 gears, 1500 clutch spring, high speed variator, and my pipe is the stock pipe but completely hollowed out. I think the pipe is hurting my top speed cuz i can only get it to about 52mph and from what everyone says it should be in the 60's. I want to get one of those tiny tachs but they only go to 9,900 rpm and i wasnt sure if that was enough. Thank you and any advise would help tremendously.

burnt_toast · Post by **burnt_toast** » Tue May 05, 2009 1:06 pm

really depends on what your pipe can push, with gutted stock i'd guess no more than 9k, 9-10k+ with good pipe

fastgtp99 · Post by **fastgtp99** » Tue May 05, 2009 3:20 pm

What kind of pipe do you recomend. If so you got any laying around that you wanna sell

evilone · Post by **evilone** » Tue May 05, 2009 4:47 pm

Dude we have the exact same setup and i too can only reach 50 mph. I have an R1 muffler. I need pg long but vtcycles is out of stock.

maddog · Post by **maddog** » Tue May 05, 2009 11:27 pm

28mm carb+ 7 to1 gears=60+mph with stock pipe.

bakaracer · Post by **bakaracer** » Tue May 05, 2009 11:43 pm

you can do 60mph with 9to1 gears too and get there fast.what brand cylinder are you running?and is the belt riding to the top of the variator.

fastgtp99 · Post by **fastgtp99** » Wed May 06, 2009 9:12 am

I bought the cheap borekit from vt cycles last year and have never had a problem. My belt rides about a 1/4 inch from the top or so.