its cracked so when i hit bumps the wire lostends and then kills the engine... but then it recaputes its selft... i know this cuz i put a spree one on there and it worked fine on bumps... but i need that one.....
My weights look just like that and yes mine too was packed with grease. The plate that was held on with the 3 screws was a biotch to get off. I installed a new one with 9 and 10 weights.
you putting heavier weights? stock is prob 8.5g,that's moving backwards
you want to build rev not lose it ,I would prob start off with 3x 8.5 and 3 x 8.0 to start ,and go from there, the smaller the jump the better,and you gotta change them in 3's and spread the weights out evenly!
I would think 1.5 to 3 g's less than stock would be a good starting point ,I run 45 g total but that's a stroker,but that's still less than stock 54 total
Well I didnt throw those worn weight away. I placed them on my scale and all but 1 read 9.9g. So I pulled the worn rubber from around the metal weight and then put them on my scale, all now read 9.1g's.
man im so upset that my coil died! uhhhh well im also looking for a wireharness... mine was a little xut up and i just quick fixed it for the spring moped ride...
