got my new parts for my dio
Moderator: Moderator
got my new parts for my dio
i just got my new parts
1000 center spring
kelli pully
28mm carb
manifold chrome
gears
i only got my carb on sofar but i will post some pics.
1000 center spring
kelli pully
28mm carb
manifold chrome
gears
i only got my carb on sofar but i will post some pics.
Just grind the teeth of the oil pump,then reinstall.dont not run the pump with out oil,it will seize and damage the crank.diomike wrote:my dad found me some plastic cap it fits do u think it will melt iam not sure if it gets hot down there.
You cant use plastic,it needs to seal perfectly, the case is under vacuum/pressure ,if it leaks you will seize.
Remember,everyone is human,even if there stupid!
No, but if you need a pump I'll send you mine -just pay for shipping ,Ive got like a dozen or so laying arounddiomike wrote:If i grind the teeth off. Would i be able to just replace the teeth if i ever had to?
Ideal is to use a oil pump plug kit ,but Ghetto works GOOD !
Remember,everyone is human,even if there stupid!
I ve seen it done and the motor still seized.jbarb wrote:I have heard that if you just make a loop, take the output line of the pump and hook it to the input line with some oil still in it, you can just have it circulate some oil to keep it going. Then you can run premix in the tank.
One the oil tends to "cook" within the pump ,since it's not beening replaced with fresh oil, Two most people forget about it and the pump leaks,runs out of oil and seizes which damages the crank,sending metal shaving into the bearing etc.
Best option is too use a plug kit and be done with it,next best is to grind off the teeth and reinstall.
The plug kit is shaped like the bottom of the oil pump ,if you just plug the top portion you are affecting crankcase volume and you will loose power
Remember,everyone is human,even if there stupid!