Page 9 of 9
Re: Spree bbk issues.
Posted: Sat Dec 10, 2016 1:03 pm
by stevespree7
HOW DO I GET NE PISTON RINGS FOR THIS KIT? I DESPERATELY NEED!!!
I'D EVEN GET A NEW PISTON AND RING KIT. I HAVE 3 JUGS. 2 GOOD PISTONS ... ONE SET OF RINGS. I'VE GOTTEN 3K... BUT GET A BIG CARB AND ADAPTER/INTAKE
Re: Spree bbk issues.
Posted: Sat Dec 10, 2016 4:33 pm
by eclark5483
PM Taz, I'm sure he can help.
Re: Spree bbk issues.
Posted: Mon Dec 12, 2016 2:19 pm
by stevespree7
I've run this kit up to 385 no problem. Just don't go over 400 or dead baby..
If you don't have a bigger intake yet do it. If you look into the math, the intake of the spree is waaaay too small for that size kit.
Re: Spree bbk issues.
Posted: Mon Dec 12, 2016 3:20 pm
by stevespree7
Yes eclark. That is what I meant. Lol hope you get it fixed!
Re: Spree bbk issues.
Posted: Mon Dec 12, 2016 3:20 pm
by MrJumps
stevespree7 wrote:I've run this kit up to 385 no problem. Just don't go over 400 or dead baby..
If you don't have a bigger intake yet do it. If you look into the math, the intake of the spree is waaaay too small for that size kit.
350*F max those bores are cast iron, but the pistons are aluminium. Your gonna melt at about 360*f at 400*f your gonna have a rod push its way through the soft piston.
Re: Spree bbk issues.
Posted: Mon Dec 12, 2016 5:21 pm
by stevespree7
Dang... well I lucky ... wow. Hahah up jet time!
Re: Spree bbk issues.
Posted: Mon Dec 12, 2016 11:19 pm
by Meatball
My Taiwan bore locked up at 380-ish
Re: Spree bbk issues.
Posted: Tue Dec 13, 2016 12:24 am
by MrJumps
Yeah 380 is when I had a soft seize too. As for the race bores out of Italian areas they can withstand a major amount of blunt trama.