I'm tired of being a snail ???? (Spree AF05 swap)

[swimmingfree]

bear
your right about that but then i was hang in dad just wating to get out lol lol
but i do like the look so today i went back to the 2.5 in the front .. one thing i wish i hade someone arond here to ride it and give me there input...
swimmingfree

[swimmingfree]

well heres the expipe ..yes there's a cone in side of it and a tip about 4 inch long
swimmingfree
you may to turn down the speakers

http://www.youtube.com/watch?v=YByUqty1 ... uqZi7UHTQ=

[swimmingfree]

here some input an what happen to the se50 motor the carbon fiber reads broke off and f up the motor big time..so if you have a se50 read block you wood like to sell let me no ..im going back to the stock one and to hel with carbon reads
swimmingfree


By freeswimming at 2011-10-16


By freeswimming at 2011-10-17

[Bear45-70]

Don't want to burst your blame bubble, but one of the big reasons for running carbon fiber/composite material reeds, other than performance increases, is that when they fail they sail thru the motor HURTING NOTHING. So your claim of screwing up your motor big time does not rung true. Now metal reeds do bad things, but not carbon fiber/composite/plastic/fiberglass reeds.

[swimmingfree]

i was zipping down the road at 40ish she back fired ones and lock up ..broke it down the bottom of the piston on both sides are gone as will as the read ... fond a peace of it in the top end ... you cood be right and it was a freak thing that happen to me ..
swimmingfree

[swimmingfree]

im new to tuning the vearter and not sure what to do so im looking for some input...
im using 3 8 gram rollers and the stock spring which is week( i think) .. when riding it get to 30 good then creep up to 40 slowly real slow ... the motor dont seem to pick up rpm from 30 to 40 but with 6 8 gram rollers it will not go over 15 mph ..
shood i get a new spring if so witch one stock 1000 1500 or 2000 for my 8 gram rollers to work and get me to top speed faster???
or get new rollers ??? if so what ware???
i do not have a rollers kit with diffident wates but i can get set of one wate...
thank for your time
swimmingfree

[swimmingfree]

i may have fond a Ruckus variator for my se50 .. need some input please..

1 will the ramp plat work from Ruckus variator????
2 shooed i get it if it works on my se50?? right now im running the restricted one...
3 im running 8 gram rollers and a yellow Center Spring getting 35 mph will i have to get ligher rollers????

swimmingfree