Page 2 of 2
Re: Gear installation problem
Posted: Fri Aug 14, 2015 8:35 pm
by dustflo
Dreaming of
But currently
Re: Gear installation problem
Posted: Fri Aug 14, 2015 11:03 pm
by Wheelman-111
Greetings:
The final big gear has a flat side and a domed side. Dome goes out toward cover. Might be a problem if reversed.
Re: Gear installation problem
Posted: Fri Aug 14, 2015 11:10 pm
by dustflo
Wheelman-111 wrote:Greetings:
The final big gear has a flat side and a domed side. Dome goes out toward cover. Might be a problem if reversed.
Dome is facing the cover and gear is pressed on all the way.
Re: Gear installation problem
Posted: Sat Aug 15, 2015 10:36 am
by dustflo
Bump
Re: Gear installation problem
Posted: Sat Aug 15, 2015 12:07 pm
by dustflo
What if i just install with 2 gaskets? Should not be this way and don't want to go that route but would probably work...
Re: Gear installation problem
Posted: Sat Aug 15, 2015 4:16 pm
by Wheelman-111
Greetings:
2 gaskets might work, but would drive me cray-zee not knowing why it was necessary. That case closed and latched with all Factory clearances before. Why won't it now? In adjusting for the new factor, what will the extra mm of clearance jack up? And how long before abnormal wear results?
Re: Gear installation problem
Posted: Sat Aug 15, 2015 4:34 pm
by dustflo
Egggggg-zackly.
Re: Gear installation problem
Posted: Sun Aug 16, 2015 6:47 pm
by dem0nk1d
Gents,
make sure that #6 isn't backwards. i know it sounds stupid but if you flip it upside/backwards everything will rotate just nicely without the cover, and as soon you tighten bolts it locks everything up. just give it a shot. Also you can double check everything and if things are rotating correctly by taking everything and transferring it into the removable case side....
Re: Gear installation problem
Posted: Sun Aug 16, 2015 6:51 pm
by dustflo
can #6 be backwards?? I thought that and flipped it over but the teeth were still facing the same way no matter what so i didn't think it was possible. My cover is bolted on can someone check this please..
Re: Gear installation problem
Posted: Sun Aug 16, 2015 6:52 pm
by dem0nk1d
dustflo wrote:can #6 be backwards?? I thought that and flipped it over but the teeth were still facing the same way no matter what so i didn't think it was possible. My cover is bolted on can someone check this please..
anything is possibly especially when things get frustrating and you have over thought about things. just double check...
easiest way to double check... is transfer everything into this case side...
then you can actually see the alignment of everything... in working order. =P