Corsa line
Moderator: Moderator
Re: Corsa line
I fixed it I'm running the s*** out of it until it looses power or * up somhow I haven't got temp past 304 and it took forever to get there so I gess I'm gona try 125 main
- swimmingfree
- CBR1000RR
- Posts: 3357
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: Corsa line
what jet are you running now??12gauge wrote:I haven't got temp past 304 and it took forever to get there so I gess I'm gona try 125 main
swimmingfree
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
Re: Corsa line
135
Re: Corsa line
I made a gasket out of card bots and gasket seal and what about not reading anymore posts
Re: Corsa line
I changed jet to from 130 to 125 it was running a little hitter but only 260-280 still then I put my 9/1 gears in and variator and it heated up to 390 in like 8 minuts so I get I'll up jet again gears realy change temp alot
Re: Corsa line
Yeah works great Icut it out perfect to muffler , pressed it real flat and coated the * out of it in 950 f. Gasket seal
- paulpauly7
- CB900F
- Posts: 1945
- Joined: Tue Feb 21, 2012 6:57 pm
- Location: nz
Re: Corsa line
maybe he thinks his packing cardboard is better than the copper ring that polini supplied with there kit
86 Nifty Fifty (spree)
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
Re: Corsa line
I checked for leaks it was the exaughst and oil plug I made a good oil plug and I am useing the copper ring but out side of it I have the shape of mount cut out of card board converd in gasket seal real thick so it smashes down sealed wen I tighten cause my muffler is off by the slightest bit I'm not a dumb * people I appriciate the help a lot I fixed it but I figure with the cylinder and piston like I showed in the pic it would get worse eventually
Re: Corsa line
My v8 pipe doesn't line up right the copper won't line up