Page 1 of 1
Quick Question!!
Posted: Thu Oct 20, 2005 6:42 pm
by cpimp
My exhaust has the little tip placed at an angle and not in the center of the back of my muffler thing (I have an elite 50). So I cant really drill the holes in a perfect circle around it, is that alright??
Posted: Thu Oct 20, 2005 6:48 pm
by deathwish
should be fine
Posted: Thu Oct 20, 2005 6:53 pm
by cpimp
alright, upon further inspection the tip is like way at the bottom of the muffler.
( .)
Like essentially where the period is if you're looking directly at the back of the muffler. So if I were to drill a circle around it I'd be drilling through the side walls of the muffler as opposed to through the back.
Is this the same muffler as the spree? And if its not i'm guessing the chambers inside are different??
Sorry for so many questions, i just want to be thorough.
Posted: Thu Oct 20, 2005 6:57 pm
by vette76
dont drill on the side. it doesnt matter where the holes are drilled, as long as they are on the back. (::.) is fine.
Posted: Thu Oct 20, 2005 6:59 pm
by cpimp
Thank you very much!!
Posted: Fri Oct 21, 2005 9:24 am
by noiseguy
On my '85, the guy drilled two holes. One of them went through the side, so there's an exhaust leak out of the main chamber. Loud. Plan to weld it up after I get the rest back together.