Page 1 of 1
suggestions on jetting for 21oko on a 44bbk spree
Posted: Fri Mar 23, 2012 1:01 am
by paulpauly7
as the title says a good pilot and main jet start point on a 21mm oko on a spree with a taz 44mm bbk
Re: suggestions on jetting for 21oko on a 44bbk spree
Posted: Fri Mar 23, 2012 1:03 am
by paulpauly7
im thinking a 42 and a 110 that would start it rich wouldnt it?
Re: suggestions on jetting for 21oko on a 44bbk spree
Posted: Fri Mar 23, 2012 2:22 am
by paulpauly7
baka , bear , tjams im looking at you three
any suggestions
Re: suggestions on jetting for 21oko on a 44bbk spree
Posted: Fri Mar 23, 2012 2:31 am
by Trafficjamz
When I built a 44mm big bore, I had the stock carb. I had a 85 or 90 jet IIRC.
Re: suggestions on jetting for 21oko on a 44bbk spree
Posted: Fri Mar 23, 2012 2:36 am
by Trafficjamz
paulpauly7 wrote:im thinking a 42 and a 110 that would start it rich wouldnt it?
sounds very rich is this the stock pipe?
Re: suggestions on jetting for 21oko on a 44bbk spree
Posted: Fri Mar 23, 2012 6:25 am
by paulpauly7
yes stock pipe just to get it running.Once running we hav lots of old exspantion chamber pipes to mod and fit oh and this is on a nz honda pal with the variated 2 bolt manifold spree motor if that makes sence . Its a taz 44 bbk with his carb kit
Re: suggestions on jetting for 21oko on a 44bbk spree
Posted: Fri Mar 23, 2012 2:18 pm
by paulpauly7
anyone?
Re: suggestions on jetting for 21oko on a 44bbk spree
Posted: Fri Mar 23, 2012 3:56 pm
by Bear45-70
Taz would be the one to ask.