drag style spree???
Posted: Wed Jun 07, 2006 6:59 pm
atarp
Honda Spree and Elite 50 Forums
Keeping Spree Elite Aero 50cc and Gyro Alive!
http://www.hondaspree.net/phpBB3/
drag style spree???
Page 1 of 5
Posted: Wed Jun 07, 2006 7:09 pm
in this same forum look under "you said it couldnt be done" its like 3 lines down from where you posted this topic. does this answer your question?
Posted: Wed Jun 07, 2006 7:17 pm
atarp
Posted: Wed Jun 07, 2006 11:32 pm
cycle imports had one that was stretched with the motor mount.diosoljah wrote:well, thats not really what I had in mind, that spree was strectched from the middle what I meant is perhaps a stretch on the motor mount, kinda like the pic below
Posted: Thu Jun 08, 2006 12:20 am
Thats what they do in Japan also with panels & exhausts, go to quik fix cycles & ask to see a catalogue.
Posted: Thu Jun 08, 2006 9:18 am
i think that someone allready tryed that.
Posted: Wed Jul 12, 2006 5:46 am
atarp
Posted: Wed Jul 12, 2006 11:02 am
i noticed that you compressed the front springs of forks to lower the front.Did you groove the leg shafts to bolt it through at the lower point? Looks like you shortened the stem too. which you would have to do.
Posted: Wed Jul 12, 2006 11:07 am
what kind of headset is that too? JAPAN? Cause the way the bolt is set up on the neck is for a japan headset.
Posted: Wed Jul 12, 2006 11:16 am
Nice start... keep us posted.
Posted: Wed Jul 12, 2006 1:19 pm
alredy done by mopedmam, that how i got the dio spree, its not a dio spree no more, its an aero spree. dragster
Posted: Wed Jul 12, 2006 1:37 pm
yeah but it never ran.
Posted: Wed Jul 12, 2006 1:37 pm
it will now, all i have to do is start it up and itle run. o and get an ignition
Posted: Wed Jul 12, 2006 2:50 pm
atarp
Posted: Wed Jul 12, 2006 4:21 pm
atarp