Page 1 of 1
Re: New Elite Build
Posted: Fri May 17, 2013 6:55 pm
by Indy Elite
what kind of wheel and hub options are available for the af16 engine? that is really my only real issue.
Re: New Elite Build
Posted: Fri May 17, 2013 7:55 pm
by inkerb2b
U can use a ruckus/met hub but have to use a 10" and no fattys
AF16 wheel options
Posted: Fri May 17, 2013 9:38 pm
by Indy Elite
12*3?
Re: New Elite Build
Posted: Sat May 18, 2013 10:22 am
by Wheelman-111
Greetings:
Engine case limits both width and height to 90/90x10. Maybe a very low-profile 12" tire could fit in height, but probably too wide. What is the reason for desiring big wide tire? It adversely affects handling.
Re: New Elite Build
Posted: Sat May 18, 2013 11:47 am
by Indy Elite
i am not interested in wide. i am interested in larger diameter.
Re: AF16 whee options - split from "New Elite Build"
Posted: Sat May 18, 2013 5:34 pm
by vette76
i am running a dio style ruckus 10x3 on mine with a 90/90/10 no issues. very close though. for a larger diameter, you would need a sym engine case.
Re: AF16 whee options - split from "New Elite Build"
Posted: Sat May 18, 2013 7:26 pm
by Indy Elite
100/60/12 is just about 1/4 in larger in diameter than 90/90/10. So if you split that in half, from the axle it should be what about 1/8 in more required room. Does a 90/90/10 have an 1/8in of room between the tire and case?
Re: AF16 whee options - split from "New Elite Build"
Posted: Sat May 18, 2013 11:07 pm
by Wheelman-111
Greetings:
Installed diameter isn't the same as running diameter. A 3.50 x 10 fits, but rubs at speeds>55 MPH. Centrifugal "growth". Not sure what if any 12" rim hubs fit the splines.