Dio gear ratio/ variator/ carb mm advice needed......

Does your Spree/Elite already run great, and you're trying to make it quicker/faster? Need a monster motor swap? Discuss your ideas here.

Moderator: Moderator

Post Reply
demenj13
Goped
Goped
Posts: 58
Joined: Sun May 12, 2013 10:15 am
Location: Rhode Island

Dio gear ratio/ variator/ carb mm advice needed......

Post by demenj13 »

Hey guys, The past few months I have been building a AF16 motor. I'm sure it's close to the same as everyone else's! With a different crank, a corsa, clutch and variator. I'm looking for a nice top end (somewhere in the neighborhood of 65+) BUT I want to get there quick!!! So I'm looking for some advice on gear ratio,variator weights and carb mm....I know it's not going to all happen at the first try and understand it's alot of trail and error (but with everyone on here I think I have a should have a good shot at more trail then error) Just looking for some input so I can put this together and feel my money was well spent!!!! Thanks......
User avatar
paulpauly7
CB900F
CB900F
Posts: 1945
Joined: Tue Feb 21, 2012 6:57 pm
Location: nz

Re: Dio gear ratio/ variator/ carb mm advice needed......

Post by paulpauly7 »

ive got the setup in my sig ive had it up to 70mph but that was on a slight down hill but 65mph on the flat .My take off is awesome im running 5k clutch springs
86 Nifty Fifty (spree)
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
Post Reply