Honda Spree and Elite 50 Forums

We are still making Spree pipes but selling them through Treatland.tv. They ordered a large batch so they should have plenty for awhile! Estimated arrival time is two weeks! Thank you all for your support!

Woah this? https://www.treatland.tv/MLM-honda-spre ... pe-381.htm

Fits the biggest bbk available by Tazland, scalable from stock? I am guessing your shipment is en route right now leading to them not having stock...

My individual setup is 48mm bbk with stock carb and exhaust, soon to receive a ported intake and reeds from the sb50. These pipes are tuned largely to an RPM range, right?

All pipes are tuned to a specific rpm range those pipes kick a.rse on stock setup and really kick butt on the bbk with the carb and intake.

Sent from my Nexus 7 using Tapatalk 2

im still hopeing to see one for the 87 elite ...
swimmingfree

I was planning on making Elite 50 pipes but I discovered that there is a rev limiter that no one knows how to get around and it keeps the bike around 30-35 mph no matter the upgrades. There might be other veriables such as gearing that keep the bike limited.

Motion Left Mopeds wrote:I was planning on making Elite 50 pipes but I discovered that there is a rev limiter that no one knows how to get around and it keeps the bike around 30-35 mph no matter the upgrades. There might be other veriables such as gearing that keep the bike limited.

huh?

um i think you got a dud bike to test

It sounds like the faulty ignition/cdi I read about on this forum, "max speed doesn't change downhill".

Motion Left Mopeds wrote:I was planning on making Elite 50 pipes but I discovered that there is a rev limiter that no one knows how to get around and it keeps the bike around 30-35 mph no matter the upgrades. There might be other veriables such as gearing that keep the bike limited.

Ah, no. Not correct. Demonstrably not correct.

What year bike? Elite 50s had several versions.

Sept 9th and treatland still does not have any MLM's. I'm going to lose my mind pretty soon here. The last piece to my build!!!

bbrmotosports wrote:Sept 9th and treatland still does not have any MLM's. I'm going to lose my mind pretty soon here. The last piece to my build!!!

Don't hold your breath.

For what getting a pipe? I PM'd MLM last week and they said they were shipping them to treat at the end of the week " last week" I pm'd them friday asking if they sent them out yet and I never got one back.

The pipes are in transit to Treats right now!

You just made my evening Devin

Motion Left Mopeds wrote:I was planning on making Elite 50 pipes but I discovered that there is a rev limiter that no one knows how to get around and it keeps the bike around 30-35 mph no matter the upgrades. There might be other veriables such as gearing that keep the bike limited.

The Honda Elite 50 (any year) made for distribution in the USA did not have an electronic rpm limiter. Similar models in Japan did have electronic limiters. The exhaust pipe was a common go to for Honda limiting USA market scooters, such as a washer welded at the exhaust flange or a smaller diameter header section.