AF05 gas in airbox
Posted: Mon Aug 05, 2019 2:32 pm
I recently installed a bbk on one of my Aeros to get it back to life
The last one was running hot because there was crud under the shroud and i didnt know it. Overheated and lost compression
New bbk is on and it shidds and gits.
Malossi had reeds for it, but they are fiberglass and didnt quite lay flush.
I upjetted the pilot to 40 from 35 and went form 80 to 90 on the main jet, stock PA carb.
It fires right up and runs really well. I noticed when i first fired it up that there is some gas dripping out of the carb intake. I had a couple people tell me to check my reeds, but they seemd good when i redid the intake and cleaned it all. Should i be using those fiberglass or is this a different problem?
I need to figure out the main jet still. I would have done that but i ate s*** on a test run due to a sticky throttle cable. Not sure if i can just lube that either. also thinking about buying gloves
The last one was running hot because there was crud under the shroud and i didnt know it. Overheated and lost compression
New bbk is on and it shidds and gits.
Malossi had reeds for it, but they are fiberglass and didnt quite lay flush.
I upjetted the pilot to 40 from 35 and went form 80 to 90 on the main jet, stock PA carb.
It fires right up and runs really well. I noticed when i first fired it up that there is some gas dripping out of the carb intake. I had a couple people tell me to check my reeds, but they seemd good when i redid the intake and cleaned it all. Should i be using those fiberglass or is this a different problem?
I need to figure out the main jet still. I would have done that but i ate s*** on a test run due to a sticky throttle cable. Not sure if i can just lube that either. also thinking about buying gloves