porting exaust?

myhonda · Post by **myhonda** » Tue Oct 30, 2007 11:59 am

there is a lump in there i want to grind out. is there anything i should be worried about?

edjo · Post by **edjo** » Tue Oct 30, 2007 5:28 pm

Don't get bits in your eyes!!

Kenny_McCormic · Post by **Kenny_McCormic** » Tue Oct 30, 2007 8:22 pm

In the pipe or in the jug? Go ahead and drill drill drill on that pipe.

stillspeeding · Post by **stillspeeding** » Wed Oct 31, 2007 1:02 am

Only port the bottom of the exhaust port.

myhonda · Post by **myhonda** » Wed Oct 31, 2007 6:49 pm

its on the jug. it isent honda ither. the hole in there is about the size of a quater but its blocked about half way by a lump of metal that needs to be grinded out.

myhonda · Post by **myhonda** » Fri Nov 02, 2007 11:25 am

do i have to take the jug off to do this?

MySpree · Post by **MySpree** » Fri Nov 02, 2007 12:14 pm

i would, you dont want to get any scraps in the engien.

myhonda · Post by **myhonda** » Fri Nov 02, 2007 2:13 pm

will i need new rings if i take the jug off? or gaskets?

Kenny_McCormic · Post by **Kenny_McCormic** » Sat Nov 03, 2007 12:38 pm

Not if your careful. Unles it has a few thousand miles on it, then you should get new rings.

myhonda · Post by **myhonda** » Sat Nov 03, 2007 1:13 pm

it has almost 2000 on it

Kenny_McCormic · Post by **Kenny_McCormic** » Sat Nov 03, 2007 10:22 pm

Might as well while you are in there then. A few peopl have horror stories of reusing rings.

Dac · Post by **Dac** » Tue Nov 06, 2007 3:21 pm

i reused some rings that came out of a fryed cylinder. they lasted 100 miles or so then busted and destroyed my new cylinder.

Kenny_McCormic · Post by **Kenny_McCormic** » Tue Nov 06, 2007 5:19 pm

Perfect example^

stillspeeding · Post by **stillspeeding** » Thu Nov 08, 2007 1:26 am

If its a spree don't even bother.

myhonda · Post by **myhonda** » Fri Nov 09, 2007 8:08 am

no its a mz moskito but i figured that this would apply for any type of small engine