help needed
Moderator: Moderator
help needed
i've been reading around this forum and i found soom great ways to increase performance of my spree, i have opened up the intake already but im sorta stuck on what to do on the pully and on the head , can any one help?
if u dont have the right tools then dont mess with the head. the pullet can be done with even a grinder. on the inner pulley just take a little off of the middle piece so the pulley halfs are a little closer. keep in mind that you will lose low end power.
00' sa-50 slammed and stretched
89' elite sb, with a 99' af16, (SOLD)
87' spree (SOLD
87' mustang gt vert kenne bell, irs.
90' mustang notch turbo drag car
12' wrx
89' elite sb, with a 99' af16, (SOLD)
87' spree (SOLD
87' mustang gt vert kenne bell, irs.
90' mustang notch turbo drag car
12' wrx
1st of all u should not need a new belt. the clutch is spring loaded to keep tension on the belt. the other thing is a variator will not fit the sprees crank. noiseguy and i have already talked aboout it and tried it and its not even close to fitting or lining up.sorry!
00' sa-50 slammed and stretched
89' elite sb, with a 99' af16, (SOLD)
87' spree (SOLD
87' mustang gt vert kenne bell, irs.
90' mustang notch turbo drag car
12' wrx
89' elite sb, with a 99' af16, (SOLD)
87' spree (SOLD
87' mustang gt vert kenne bell, irs.
90' mustang notch turbo drag car
12' wrx