Honda Spree and Elite 50 Forums

i have a sym dd50 i exchange it with a honda elite engine( af16) on the fuel pump of sym dd 50 one hose is connected to the carb and one is near/under the oil pump/injector of sym dd50 but on the af16 engine there is no nipple to put on on that other hose,i don't know what to do. what will i do on the extra hose of the fuel pump pls help

What was wrong with the sym motor? You need to re-tap you manifold for vaccum

there is nothing wrong w/ the sym motor ,what do you mean re-tap manifold vaccum

how do i do that

Like this,if you are running a fuel pump ,you need to tap your manifold,like you see
On the picture

i have that on my ct manifold but its not located there on the picture its located at the top can i put tap it there?

Ok,no if you are running a pump,it needs to be where you see it in the pic

Ok so what will I do on the top nipple close it?or leave as it is.

Close it

Thank you sir...

thanks g9

do have any idea what size of nipple port and where to buy it thank you..

Downsouthdio wrote:Like this,if you are running a fuel pump ,you need to tap your manifold,like you see
On the picture

Jealous of your reed cage

chamisataza wrote:do have any idea what size of nipple port and where to buy it thank you..

I would get something similar to the size on your pump?

You can get these brass Barb fittings at any hardware store in the plumbing side. You will also need to get a NPT tap for whatever size you end up going with.

thanks j248 ill go to lowes