Been a long time lurker here, figured it was time to show my project. I picked up this '87 Spree on CraigsList for $50. It hadn't run in years and was on the side of a house under the eaves so it was somewhat protected.
![Image](http://i889.photobucket.com/albums/ac96/gajfontes/Spree/CL1.jpg)
![Image](http://i889.photobucket.com/albums/ac96/gajfontes/Spree/CL2.jpg)
![Image](http://i889.photobucket.com/albums/ac96/gajfontes/Spree/Engine.jpg)
So far I have basically been taking it apart and buying little bits here and there on Ebay and reading a lot on these forums.
After dis-assembly, I found the jug was worn beyond spec so I got Taz's 44mm BBK. I cleaned up the aluminum a bit...
![Image](http://i889.photobucket.com/albums/ac96/gajfontes/Spree/Polished.jpg)
and cooked out the gunk in my muffler, (note the flame coming out of the exhaust pipe in the lower left)
![Image](http://i889.photobucket.com/albums/ac96/gajfontes/Spree/BurningMuffler.jpg)
I haven't weighed it yet, but I'll post the before and after weight's of the muffler.
George