Spree Engine Swap: Honda Elite CH80 onto Spree
Moderator: Moderator
Re: Spree Engine Swap: Honda Elite CH80 onto Spree
I've been trying out this carb on the ch80, it took a lot of trial and error getting the jetting right. I already road a few hundred miles with it, put a zip tie on the manual chock that leads up to under the seat. If I try to hit WOT off a dead stop it will cut out, so you have to roll into throttle. I guess that's just the nature of a round slide carb on a engine designed for a economical CV carb. My top speed has improved, I still might experiment with a larger main jet.
Re: Spree Engine Swap: Honda Elite CH80 onto Spree
[/url][/quote]
Great work!!! It amazing to see what guys can do with some time and imagination.
Great work!!! It amazing to see what guys can do with some time and imagination.
2000 Elite SR50 -THE PURPLE NURPLE
50mm BBK (tai)
26mm OKO (round slide) 135 Main Jet
V-8 pipe
39/18 secondary gears (7.583:1 ratio)
36 grams in Prodigy variator
Malossi Delta Clutch & WIng Bell- Thanks RED EFT
65mph GPS (on the freeway)
50mm BBK (tai)
26mm OKO (round slide) 135 Main Jet
V-8 pipe
39/18 secondary gears (7.583:1 ratio)
36 grams in Prodigy variator
Malossi Delta Clutch & WIng Bell- Thanks RED EFT
65mph GPS (on the freeway)
Re: Spree Engine Swap: Honda Elite CH80 onto Spree
Thanks, I made a flange mount intake into a spigot mount. It's still only 18mm and the carb is a 18mm round slide, which is a huge upgrade from the stock 18mm cv carb. Someday I'll try to fit up a 20mm round slide...deuce217 wrote:Great work!!! It amazing to see what guys can do with some time and imagination.
Re: Spree Engine Swap: Honda Elite CH80 onto Spree
Nice work!
Open comments pertaining to my scooter are entertained and promoted by me.
Re: Spree Engine Swap: Honda Elite CH80 onto Spree
Thanks, Hope my spree seat is more comfortable after all this work.Ambientek wrote:Nice work!