the forks lowers I am getting are straight while the spree fork lowers kinda bend in so a wider wheel will work. But it needs to be disk brake wheel.ped wrote: Hi Z. met wheel too wide for spree forks. not sure on the dio wheel. elite wheel will fit with the 275-10 tire.
new to me spree with pics
Moderator: Moderator
-
- Goped
- Posts: 54
- Joined: Wed Aug 03, 2016 12:57 am
- Location: Lethbridge Alberta Canada
Re: new to me spree with pics
-
- Goped
- Posts: 54
- Joined: Wed Aug 03, 2016 12:57 am
- Location: Lethbridge Alberta Canada
Re: new to me spree with pics
my front brake cable doesn't seem to move when I squeeze the lever. any idea what could cause this?
-
- Goped
- Posts: 54
- Joined: Wed Aug 03, 2016 12:57 am
- Location: Lethbridge Alberta Canada
Re: new to me spree with pics
what is a good inexpensive shock upgrade for a stock spree? I am 210 lbs
Re: new to me spree with pics
"inexpensive" and "upgrade" usually don't go in the same sentence. Question is: are you looking for a stiffer spring or one with more travel? or both?
I need to find some new haters...the ones I have are starting to like me.
-
- Goped
- Posts: 54
- Joined: Wed Aug 03, 2016 12:57 am
- Location: Lethbridge Alberta Canada
Re: new to me spree with pics
firmer as it seems my stock one is a little on the well worn side. I am thinking a ruckus oem shock might do the trick.
-
- Elite
- Posts: 392
- Joined: Mon Feb 01, 2016 11:04 pm
- Location: beaverton, or
Re: new to me spree with pics
A friend of mine just got an elite with back brake cable frozen. I had to remove cable to bend it around and free it up while squirting gas down into the tunnel with a squeeze bottle. That did the trick. I was just corroded from sitting.
2000 Honda SR (purple swurp)
corsa
naruku
polini 21 cp 36/106 pod filter
polini vari 5.5 gram
zx trans
Polini evo2 clutch/bell yellow springs (slacked) yellow contra
Yasuni C16
stock crank/gears=wheelie machine
70 mph/12,470 rpm Trail tech vapor verified
corsa
naruku
polini 21 cp 36/106 pod filter
polini vari 5.5 gram
zx trans
Polini evo2 clutch/bell yellow springs (slacked) yellow contra
Yasuni C16
stock crank/gears=wheelie machine
70 mph/12,470 rpm Trail tech vapor verified
Re: new to me spree with pics
Make sure you run wd40 or some type of lubricant if your gonna go that route. But I have to say that my rear cable was siezed and when I finally unsized it, it had little to no "meat" to the cable and snapped so for 20 bucks pick uo a used or sa50, etc simular scooter drjm brake cable and play it safe. Unless you wanna free up a cable and inspect it, my bike was siting for close to 25 years.Meloshameless wrote:A friend of mine just got an elite with back brake cable frozen. I had to remove cable to bend it around and free it up while squirting gas down into the tunnel with a squeeze bottle. That did the trick. I was just corroded from sitting.
1993 ch80, swapped with a ch250
2021 DRZ400sm
2021 DRZ400sm
- Wheelman-111
- Moderator
- Posts: 11321
- Joined: Wed Oct 22, 2008 5:09 pm
- Location: Deepinnaharta, Texas
Re: new to me spree with pics
Greetings:
Another thing to evaluate is the cam arm in the brake panel. Steel shaft in a cast Al-You-Minnie-Yum panel corrode fast if the grease dries out and gets really stiff. This can in turn cause rapid cable wear. This critical system should not be mended on the cheap, or you bet your life. Disassemble, clean and grease liberally, and pony up for new cable and components if any doubt exists.
Another thing to evaluate is the cam arm in the brake panel. Steel shaft in a cast Al-You-Minnie-Yum panel corrode fast if the grease dries out and gets really stiff. This can in turn cause rapid cable wear. This critical system should not be mended on the cheap, or you bet your life. Disassemble, clean and grease liberally, and pony up for new cable and components if any doubt exists.
Wheelman-111
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
-
- Goped
- Posts: 54
- Joined: Wed Aug 03, 2016 12:57 am
- Location: Lethbridge Alberta Canada
Re: new to me spree with pics
I am tossed on either go the cheap route and swap in a 87 Aero 50 AF05e variated engine into my spree or pony up for an AF16 or AF18. I am not looking for a huge top speed gain just more umph
Problem is the 87 afo5e doesn't have kick start.
Problem is the 87 afo5e doesn't have kick start.
- eclark5483
- CB900F
- Posts: 1437
- Joined: Thu Apr 14, 2016 5:15 am
- Location: Spencer Iowa
- Contact:
Re: new to me spree with pics
By that, you mean YOURS doesn't? Mine does.z50 chopper wrote:I am tossed on either go the cheap route and swap in a 87 Aero 50 AF05e variated engine into my spree or pony up for an AF16 or AF18. I am not looking for a huge top speed gain just more umph
Problem is the 87 afo5e doesn't have kick start.
- Wheelman-111
- Moderator
- Posts: 11321
- Joined: Wed Oct 22, 2008 5:09 pm
- Location: Deepinnaharta, Texas
Re: new to me spree with pics
Greetings:
1985 was the only year Aero without the kicker, from all I've read. For sure both '87s I have owned had one. What's the engine serial number?
1985 was the only year Aero without the kicker, from all I've read. For sure both '87s I have owned had one. What's the engine serial number?
Wheelman-111
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
-
- Goped
- Posts: 54
- Joined: Wed Aug 03, 2016 12:57 am
- Location: Lethbridge Alberta Canada
Re: new to me spree with pics
Engine numberWheelman-111 wrote:Greetings:
1985 was the only year Aero without the kicker, from all I've read. For sure both '87s I have owned had one. What's the engine serial number?
AF05E-3202071