1983 Aero 50 hard start when cold
Moderator: Moderator
- spree picker
- Spree
- Posts: 146
- Joined: Tue Sep 27, 2011 9:34 am
- Location: missouri
1983 Aero 50 hard start when cold
I PICKED UP A 83 aero with 795 miles runs great after I get it started but when it sits for awhile hard to start very long crank if i give it any gas it dies,after several tries it starts
I give old Sprees a new life
- swimmingfree
- CBR1000RR
- Posts: 3357
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 1983 Aero 50 hard start when cold
you bystarter may be bad..
do a compression test as well it wont hurt..
swimmingfree
do a compression test as well it wont hurt..
swimmingfree
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
- spree picker
- Spree
- Posts: 146
- Joined: Tue Sep 27, 2011 9:34 am
- Location: missouri
Re: 1983 Aero 50 hard start when cold
the bystarter test good like 5 ohms
I give old Sprees a new life
- swimmingfree
- CBR1000RR
- Posts: 3357
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 1983 Aero 50 hard start when cold
im no you read it a lot but clean the carb... if the hole blow the bystarter is plug it may be what is going on
swimmingfree
swimmingfree
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
Re: 1983 Aero 50 hard start when cold
I agree with swimming free, also check to make sure the o-ring on the bystarter isnt cracked or damaged
1986 Spree/ Eve af16 swapped 65cc Prodigy vari 8g 9:1 Ruima gears
21mm OKO 42/100 32:1 45mph kymco zx exhaust
1994 Elite S 17.5mm Arreche, Daytona reeds, SEF ramp, pump plugged
1987 Elite SE50 af16 swapped
1989 Elite E SB50p
2003 Yamaha Zuma
21mm OKO 42/100 32:1 45mph kymco zx exhaust
1994 Elite S 17.5mm Arreche, Daytona reeds, SEF ramp, pump plugged
1987 Elite SE50 af16 swapped
1989 Elite E SB50p
2003 Yamaha Zuma
Re: 1983 Aero 50 hard start when cold
I've got two '83s and they both have this problem. One though, after riding it more frequently, the problem seems to be subsiding. Either way, when you clean the carb, note the pinhole orifice in the float bowl, and the emulsion tube that just presses in the carb under the mainjet. These are both easily overlooked. I think air screw setting may have helped too.
RZ Rob
RZ Rob
- spree picker
- Spree
- Posts: 146
- Joined: Tue Sep 27, 2011 9:34 am
- Location: missouri
- swimmingfree
- CBR1000RR
- Posts: 3357
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 1983 Aero 50 hard start when cold
there is a small hole you can see when you look now were the slide goes its the hard part to get clean if you cant see thou it its not clean anuff use compress air or a spray cleaner to make sure its clean
swimmingfree
swimmingfree
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
- spree picker
- Spree
- Posts: 146
- Joined: Tue Sep 27, 2011 9:34 am
- Location: missouri
Re: 1983 Aero 50 hard start when cold
Ok,took carb apart everything got blown out good will put back together tomorrow.I didn't seen any restriction wish me luck!
I give old Sprees a new life
Re: 1983 Aero 50 hard start when cold
RZRob wrote:I've got two '83s and they both have this problem. One though, after riding it more frequently, the problem seems to be subsiding. Either way, when you clean the carb, note the pinhole orifice in the float bowl, and the emulsion tube that just presses in the carb under the mainjet. These are both easily overlooked. I think air screw setting may have helped too.
RZ Rob
1983's??????? I don't think so.
Bear 45/70
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
- Wheelman-111
- Moderator
- Posts: 11325
- Joined: Wed Oct 22, 2008 5:09 pm
- Location: Deepinnaharta, Texas
Re: 1983 Aero 50 hard start when cold
Greetings:
Bear, Why doubt ye the eighty-three? Could be '84s I guess. One thing's for sure: They're WAAAAYY cleaner than any scooter that old has any right to be! Nice quiver, RZ.
Bear, Why doubt ye the eighty-three? Could be '84s I guess. One thing's for sure: They're WAAAAYY cleaner than any scooter that old has any right to be! Nice quiver, RZ.
Wheelman-111
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
- spree picker
- Spree
- Posts: 146
- Joined: Tue Sep 27, 2011 9:34 am
- Location: missouri
Re: 1983 Aero 50 hard start when cold
looks like 83 to me,as far as clean * yea I have 2 84 gyros and 2 85 sprees just as clean.Very nice collection thanks for the pics.
I give old Sprees a new life
Re: 1983 Aero 50 hard start when cold
Because I didn't look close at the picture and it bit me in the butt.
Bear 45/70
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
- spree picker
- Spree
- Posts: 146
- Joined: Tue Sep 27, 2011 9:34 am
- Location: missouri
Re: 1983 Aero 50 hard start when cold
soaked and cleaned,rode last night .It started up this morning looks like I'm riding the old girl to work.
I give old Sprees a new life